Does anyone know the proper set up for the Hobie 16 jib furler system ? I've just installed the full kit (including the new sail), but I'm a little confused about the sequence of events for raising the mast and adjusting the mast rake. I assume I'll still need some kind of line to replace the halyard to lead to my winch for raising the mast solo, while the jib is shackled to the swivel at the shroud shackle. Once the mast is raised and the bottom of the sail is shackled to the furler I'll then cleat off the raising line, right ? How do I then adjust mast rake since the 10 hole is up at the shroud shackle ? Or is it set it once and forget it from here on when using the roller furler jib ?
Thanks for any tips or pix of the best way to rig this up...
|