Return to Hobie.com
Hobie Forums
It is currently Fri Jul 18, 2025 10:15 am

Board index » Hobie Kayaking / Fishing » Hobie Mirage Pro Anglers

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
Bawitheba
 Post subject: Bent md 180
PostPosted: Thu Oct 27, 2016 12:37 pm 
Offline
Site Rank - Deck Hand

Joined: Mon Oct 17, 2016 4:55 am
Posts: 4
I beached my pro angler today. How do I get the mast out so I can change it out?
Top
 Profile  
 
Jbernier
 Post subject: Re: Bent md 180
PostPosted: Thu Oct 27, 2016 12:59 pm 
Offline
Site Rank - Old Salt

Joined: Wed May 28, 2003 1:12 pm
Posts: 1464
Remove the fin (un-srew the adjuster screw on the rear of the fin) then take it out and put the mast in a vise (the mast has a notch on near the tip so you can grab it with a wrench and unwind it)

_________________
Jacques Bernier
http://www.hobie.com/
http://www.facebook.com/HobieCatCompany
Top
 Profile  
 
Roadrunner
 Post subject: Re: Bent md 180
PostPosted: Thu Oct 27, 2016 7:22 pm 
Offline
Hobie Approved Guru

Joined: Sat Nov 12, 2005 10:46 pm
Posts: 3017
Location: Escondido
OR, after removing the fin,you can try straightening the mast without taking it off. for most bends that works fine. 8)
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Hobie Kayaking / Fishing » Hobie Mirage Pro Anglers

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group