Return to Hobie.com
Hobie Forums
It is currently Sat Apr 27, 2024 2:38 am

Board index » Hobie Kayaking / Fishing » Hobie Mirage Passport

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
Dockan
PostPosted: Thu Jul 21, 2022 10:43 am 
Offline
Site Rank - Deck Hand

Joined: Sat Jul 16, 2022 9:14 am
Posts: 2
The scupper holes on my passport 10.5 are not fully drilled out. This prevents my kayak cart from being able to seat into the scupper holes properly. Should I drill them out or will I cause my kayak to leak and take on water? (Ps, I bought the 12.0 passport at the same time and it's scupper holes are not blocked, meaning I can get it on my kayak cart)
Top
 Profile  
 
Jbernier
PostPosted: Thu Jul 21, 2022 1:17 pm 
Offline
Site Rank - Old Salt

Joined: Wed May 28, 2003 1:12 pm
Posts: 1464
Sorry to hear that - should have been caught in our factory or at the dealer PDI inspection.... you can have a dealer help - or if you're able - A 1-3/8” hole saw would work best. You can also drill a smaller hole in the middle and use a Dremel tool to open it up to 1-3/8”

_________________
Jacques Bernier
http://www.hobie.com/
http://www.facebook.com/HobieCatCompany
Top
 Profile  
 
Dockan
PostPosted: Fri Jul 22, 2022 4:16 am 
Offline
Site Rank - Deck Hand

Joined: Sat Jul 16, 2022 9:14 am
Posts: 2
Thanks, I will try drilling the 1 and 3/8 diameter hole.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Hobie Kayaking / Fishing » Hobie Mirage Passport

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group