KayakingBob wrote:
I mount a 1" ball mount just forward of each pocket on the gunnels, left for my GPS and right for my Fish Finder. I ran the transducer wire through the fitting into the hull and mounted the transducer to the bottom internally forward between the mast cup and the Mirage drive (out of the way). I tried an external transducer mount, but it made way to much noise at sailing speed.
The battery I actually mount in a waterproof box on deck, strapped to the aka xbar forward of the Mirage drive or aft behind the seat depending on how I'm loaded (trim). When not in use, the transducer wire is "capped", the terminals coated with di-electric grease, and stored out of the way in the right pocket.
Works well for me. Out of the way, but just within reach to press buttons. I can post more details of any part you wish.
I must buy a Fishfinder & gps for my TI
-
I thought a lowrance elite 4 x dsi--elite 5 x dsi, your advice???
-
-
the transducer will be inside? external? What model coupled transducer tips?
-
-
very important: you can publish photos with details of how you placed and passed the wiring? battery solution, transducer etc etc.
-
-
I would avoid puncture and drill as close as possible to the kayak.
For this I would like to use and adopt the railblaza system for my fishing gear.
-
-
thank you