Return to Hobie.com
Hobie Forums
It is currently Sun Apr 28, 2024 2:02 pm

Board index » Hobie Kayaking / Fishing » Hobie Mirage Pro Anglers

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
raiderdude
PostPosted: Fri Feb 10, 2023 8:35 am 
Offline
Site Rank - Deck Hand

Joined: Fri Feb 03, 2023 9:38 am
Posts: 5
Just bought watersnake 24 trolling motor for my PA12. I am in process of removing head and wires to shorten the shaft. My issue is removing the spade connectors. I have started on the blue wire but it is impossible to remove. I have wiggled it side to side and used needle nose pliers to try and pull off. Any ideas on best way to remove? I dont want to break anything. If I can't get it off, I may have to mount trolling motor on side of kayak.

A second question is : Is there a performance difference with mounting it in the stern vs in the mirage drive well vs side mounting it?
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Hobie Kayaking / Fishing » Hobie Mirage Pro Anglers

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group