Hi,
I'm following this thread and have posted one of my own with not attention. I just want to clearly understand, on my 2011 PA 14 the rail hardware is a SS allen bolt and a brass hull threaded insert (not a nut and washer that once the bold is removed will just fall down into the hull)? Reason why is I can't imagine the royal PITA it would be to get to the underside to hold a nut (see image below).
My recently used purchased 2011 PA 14 seems to have the fwd port bold spinning and not seating, suspect what's going on here with this user. So my plan is to reset the insert with Loctite AA 3035 adhesive, what I used to repair the cam columns on my 2008 Revo here:
https://www.hobie.com/forums/viewtopic. ... 24#p305324Again, it's a threaded insert correct? Not a bolt and loose nut?