Hello to the Hobie forum (sorry forgot an introduction),
Tigger from downunder here, have bought my first Hobie cat which I need some help to sort out.
If someone could tell me what this rope setup is meant to control on my 2002 Tiger that would be much appreciated.
Basically rope goes from cleat just forward of dagger under tramp to front block (under beam) then to block under rear beam, it then repeats on the other side with a block hanging on the line between 2 rear blocks.
I have mast spanner control on boom.
I have two line spinnaker control but maybe this is for single line but I think not??
I have jib traveller limiter going to small fixed stainless cleat on rear edge front beam.
Then the question of the crazing on hull edge (looks worse in the photos), only one gunnel of Port bow area (outer edge only). Is this common? possible causes?? Still feels solid to the hand bump.
Thanks all.