Wings change angle of main sheet, any ideas?

Wings have been added to my 1981 hobie 18 and also upgraded 3 wide harken mainsheet block set up. My question is this, when operating the main sheet from the bench, the angle causes the main to cleat to easily , I would like to have the main sheet "live" without cleating, how do you adjust angle to match sitting on bench?

Harken wedge blocks.

harke n wedges Fairleads and
eyestraps designed specifically for each
Cammatic model, the wedges put the
Cammatic on a 15 degree angle for ease
of cleating or releasing. The fairleads are
molded into a replacement base for each
Cam-matic. The eyestraps are designed
to be held in place over the cams by the
mounting screws.
Wedge Kits
H145 (H150 & H365)
H297 (H423)
WIRE FAIRLEADS
H298 (H150 & H365)
H284 (H423)
EYESTRAPS
H137 (H150 & H365)
H201 Low (H150 & H365)

_________________
Rich Vilvens
F-18 5150
[email protected]
http://www.sailblogs.com/member/f-185150sailing/

There are adjustment screws on the sides of the block. The whole jaw assembly can pivot. Loosen a screw on each side. Slide the assembly to the desired position and re-tension the screws.

_________________
Matt Miller
Former - Director of Parts and Accessory Sales
Warranty and Technical Support
Hobie Cat USA
(Retired 11/7/2022)