Mast step link kit drill bit question.

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

paragon1970

Post subject: Mast step link kit drill bit question.

Posted: Fri May 02, 2014 3:45 pm

Site Rank - Admiral

Joined: Thu May 23, 2013 12:02 am
Posts: 165
Location: London

Hi Folks,
I have just received my H14 / H16 mast step link kit from Hobie Center UK and it appears I will need to drill a hole for the link pin on both my H16 mast(s) I have two and the H14 mast base.
The instructions state to use a 6.3mm drill bit, this is an unusual size of which I do not have.
I do have in my possession a 6mm and a 6.5mm HSS drill bit, do you think it would be adequate to use the 6.5mm or could I expect some issue by doing so?
I ask as this is the first time I will be attempting this procedure.

Thanks
SRG

_________________
Hobie 14 Turbo (~1979)
Hobie 16 Carumba (1983)
Hobie 16 1990 (storm damaged)
Hobie 16 1996 (my latest)

Top

AntonLargiader

Post subject: Re: Mast step link kit drill bit question.

Posted: Fri May 02, 2014 4:38 pm

Site Rank - Old Salt

Joined: Sun Sep 20, 2009 4:00 pm
Posts: 569
Location: Charlottesville, VA

I bet they said 6.3mm because it's 1/4". Not that precise.

_________________
'00 H16 #104691
'78 H16 #32692 ex-rental [gone]
Old Holsclaw trailer
My Hobie 16 pages

Top

Page 1 of 1

[ 2 posts ]

Board index » Hobie Catamaran Sailing » Hobie 16

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to: