TI Hull Seperating at RotoMold Joint

https://www.flickr.com/photos/a8cmg/15549577158/
https://www.flickr.com/photos/a8cmg/15115066724/

I have a pronounced edge on the seam of the hull. What the heck is going on? When I run my finger along the seem I can feel an edge. Is the hull loosing its seal? I just noticed it today. This is a 2012 hull The warranty expired in February

Is this something the plastic welder can fix, or is this the beginnings of a more pronounced hull issue.

_________________
https://www.flickr.com/photos/a8cmg/
https://www.youtube.com/user/mastery415/videos

The two halves the mold don't always line up perfect - sometimes you have a step along the edge in areas - that looks normal. It isn't two pieces - it's one solid part of plastic (look inside and you'll see what I'm saying. The outside gets trimmed by hand, and they all vary.

_________________
Jacques Bernier
http://www.hobie.com/
http://www.facebook.com/HobieCatCompany

Thank you for responding. I see you work for HOBIE. It is unusual cause I never noticed these before. I will take your advice and peek inside.

_________________
https://www.flickr.com/photos/a8cmg/
https://www.youtube.com/user/mastery415/videos