Return to Hobie.com
Hobie Forums
It is currently Thu Sep 11, 2025 10:51 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 19 posts ]  Go to page Previous  1, 2
Author Message
 Post subject: Re: My first pitchpole
PostPosted: Mon Jun 08, 2009 1:58 pm 
Offline
Site Rank - Old Salt

Joined: Sat Aug 05, 2006 5:44 pm
Posts: 439
Location: Oshkosh, WI
Love the explanations with names.. good times.

I still haven't pitched nor have I even capsized mine... I know, I'm not doing it right... I let it out when it gets a bit hairy... although, I have nearly pitched backwards in the face of a storm and an unplanned jibe with me on the wrong side of the tramp.

Is there a way I can test righting capabilities along with mast waterproofing in shallow waters? Lake Winnebago is 15' deep tops... usually 5-10.

_________________
1982 H16 (C:\Worthy)
Yellow/White Prism type sails


Top
 Profile  
 
 Post subject: Re: My first pitchpole
PostPosted: Mon Jun 08, 2009 9:58 pm 
Offline
Site Rank - Old Salt

Joined: Wed Jul 06, 2005 2:15 pm
Posts: 1199
Location: Oakland, CA
Barren wrote:
Is there a way I can test righting capabilities along with mast waterproofing in shallow waters? Lake Winnebago is 15' deep tops... usually 5-10.

Yep. You and a friend push the boat into water 3 feet deep, then one grabs a trap handle and pulls while the other lifts the opposite hull. When it reaches the tipping point he who holds the trap handle moves aft out of the way of the main sail as it splashes down. That's it. Now right it according to the Hobie rigging manual. On the water in a real capsize it won't be quite the same as near the beach as waves and wind affect righting, but it's better than learning to shoot in a foxhole.

One tip - point the mast at least 45 degrees into the wind so that the wind pressure on the tramp assists in righting. To point the mast into the wind there are two places I go, the mast head or the bow, and in both cases I try to create as much drag in the water as I can so that the wind weathervanes the rest of the boat around me.

Two tip - when reaching the righting moment and the boat begins to come down on both hulls, hold onto the dolphin striker or the windward hull to keep the boat from capsizing again without you on it. Of course you remembered to uncleat the main, the traveler, and the jib before attempting to right the boat.

Three tip - there's no reliable answer to the necessary weight needed to right a 16, but 230 lbs. and good technique should do it.

Testing the mast is easy, just remove it from the boat and dunk it in the lake, then watch for bubbles. No bubbles is good. If there are bubbles at a rivet, replace the rivet. If there are bubbles near the base or head, reseal them.


Top
 Profile  
 
 Post subject: Re: My first pitchpole
PostPosted: Tue Jun 09, 2009 6:25 am 
Offline
Site Rank - Old Salt

Joined: Sat Aug 05, 2006 5:44 pm
Posts: 439
Location: Oshkosh, WI
Thanks! I think I'm going to hit up the mast with some new sealer before I put it on the dock for the summer... It still doesn't feel like summer here in Wisconsin...

_________________
1982 H16 (C:\Worthy)
Yellow/White Prism type sails


Top
 Profile  
 
 Post subject: Re: My first pitchpole
PostPosted: Sat Jun 20, 2009 4:21 am 
Offline
Site Rank - Captain

Joined: Mon Jun 08, 2009 5:41 am
Posts: 32
Location: Lake Livingston, Texas
Fascinating and fun reading this topic :D . Haven't yet had the 'opportunity' to pitchpole - only been out once on my new Bravo, but in a pretty good breeze. Several times I had to slide my butt astern as far as possible to keep the leeward hull from burying. Next time out I plan to dump her (hopefully NOT pitchpole) just to learn how to right her (in light air) so I'm prepared when it happens in heavy air. Love the fact that I can easily roll in the main if it's picking up too much water - that should also allow me to bring her back on her feet in pretty much any direction.

_________________
Bob Reeves
Lake Livingston, Texas
Image
My home page


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 19 posts ]  Go to page Previous  1, 2

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group